Welcome


Law should be interactive.

Rabbit Crowd Library is an experiment in enabling people to interact with the law directly without bias.

Give law accountability. Use - , and to comment and respond to text you agree and disagree with.

0
0
0
39:3b-10. School Bus Seats, Seat Belts, Child Restraint Systems, Regulations

1. In addition to the requirements in Federal Motor Vehicle Safety Standard No. 222 (49 CFR s.571.222) concerning school bus passenger seating and crash protection, each school bus as defined in R.S.39:1-1 shall be equipped with seats of a minimum seat back height of 28 inches, or 24 inches as measured from the seating reference point, and seat belts of the lap belt type for each seating position on the bus or other child restraint systems that are in conformity with applicable federal standards. The design and installation of seat belts or other child restraint systems that are in conformity with applicable federal standards shall conform to the regulations promulgated by the State Board of Education, in consultation with the Director of the Division of Motor Vehicles in the Department of Law and Public Safety. The State board shall promulgate regulations, pursuant to the "Administrative Procedure Act," P.L.1968, c.410 (C.52:14B-1 et seq.), for the design and installation of seat belts or other child restraint systems that are in conformity with applicable federal standards.

As used in this section, "seating reference point" shall be defined as the term is defined in 49 CFR s.571.3.

L.1992,c.92,s.1.

Share this law:
Facebook Twitter LinkedIn Pinterest Reddit
Local Government
New Jersey
0
0
0
Phil Murphy
Phil Murphy
January 16, 2018 -
Democratic
1-609-292-6000
125 West State Street, Trenton, NJ, 08625

Keywords
seat
belt
federal
conform
systems
child
restraint
belts
standards
applicable